Git

From VoIPmonitor.org
Jump to navigation Jump to search

GIT upload

If you attempt to push a large set of changes to a Git repository with HTTP or HTTPS, you may get an error message such as error: RPC failed; result=22, HTTP code = 411. This is caused by a Git configuration default which limits certain HTTP operations to 1 megabyte. To change this limit run within your local repository

git config http.postBuffer *bytes*where bytes is the maximum number of bytes permitted. For exmaple:

git config http.postBuffer 524288000

self compiled sniffer from GIT sources

If customer use self compiled sniffer from git, (napatech card card not supported in static binaries provided by voipmonitor.org) set in sniffer's /etc/voipmnitor.conf

upgrade_by_git = yes
git_folder = /usr/src/voipmonitor-git

The sniffer will perform (after click on UPGRADE in GUI) git pull,configure,make_clean,make, service voipmonitor stop, make install, service voipmonitor start